Frequently Asked Questions; Service; Troubleshooting - Energetics E-202 Instruction Manual

User Manual

Frequently asked questions

How are the computer settings reset?
1. Reset: Hold the RESET-key for a minimum of 2 seconds and all functions
will be reset . Information not saved will be lost .
2. Power supply: If removing the batteries from the back of the computer
disconnects the power supply, all functions are reset and information not
saved it lost .
Can the workout/program be interrupted?
The training is interrupted when the computer no longer receives a signal
from the unit, the values will no longer be recorded . You can resume training
and the values continue counting .
!
If the training is interrupted for more than 4 minutes the compu-
ter stops and all values recorded so far are lost.
Heart rate monitoring – can chest strap and hand pulse sensors be
used at the same time?
The E-202 has no receiver for a chest strap signal .

Service

Troubleshooting

Computer display is not working
• The computer might not be getting power. Check if the batteries are
inserted properly .
• The batteries might need to be replaced.
• Contact your local ENERGETICS-dealer if you have checked all connections
and the display is still not working .
The computer does not show values during the workout
• Check if the data cable is connected properly.
Heart rate (PULSE) shows no or incorrect read out
• Check if your palms have proper contact with the sensors. Both palms have
to be in contact with the sensors simultaneously . The display may be on a
slight delay .
• Check all cable connections.
• Try moistening your hands if they are dry.
The computer has shut down
In rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge . Normally the E-202
restarts on its own .
If this should not occur a restart can be performed by removing the batteries
for a moment and reinserting them .