Adding Engine Oil - MacDon M1170NT5 Operator's Manual

3. Clean around filter head (A) and remove the filter.
NOTE:
Check that the gasket is removed from the filter head.
4. Clean the gasket mating surface.
5. Apply a thin film of clean oil to the gasket on the new filter.
Refer to 5.1.5 Filter Part Numbers, page 234
recommended oil filter.
6. Screw the new filter onto the filter mount until the gasket
contacts the filter head.
7. Tighten the filter an additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install the oil filter.
Overtightening can damage the gasket and filter.
8. Properly dispose of the used oil filter.

Adding Engine Oil

DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Open the hood. For instructions, refer to
2. Shut down the engine, and remove the key from the ignition.
3. Clean the area around filler cap (A) and remove it by
turning the cap counterclockwise.
4. Carefully pour in 11 L (11.6 US qts) of new oil. A funnel is
recommended to avoid spillage. Refer to
Fluids, and System Capacities, page 232
specifications.
CAUTION
Do NOT fill above the HIGH mark.
5. Replace oil filler cap (A) and turn it clockwise until snug.
6. Check the oil level. For instructions, refer to
7. Close the hood. For instructions, refer to
215922
MAINTENANCE AND SERVICING
for the
Figure 5.85: Engine Oil Filter
5.3.1 Opening Hood, page
5.1.4 Lubricants,
for oil
Figure 5.86: Oil Filler Cap
5.7.1 Checking Engine Oil Level, page
5.3.2 Closing Hood, page
290
A
239.
270.
240.
A
Revision A