MacDon M1170NT5 Operator's Manual page 207

NOTE:
Pressing X icon (A) on the screen (or pressing the HOME,
BACK or any GSL button [buttons not shown]) at any time
during the calibration process will EXIT the calibration
procedure without saving your progress. The engine speed
will also return to the original rpm prior to starting the
calibration process.
NOTE:
If a sensor goes out of its normal operating range during
the calibration process, calibration will stop and a message
will appear on the screen indicating that a sensor is out
of range.
8. When stage one of the calibration is complete, press PLAY
icon (A) on the screen to continue with stage two of the
calibration process.
9. When stage two of the calibration is complete, press
RESUME icon (A) on the screen to configure the HEADER
FLOAT setting, or press HOME or BACK button (not shown)
to exit.
NOTE:
The engine speed returns to the speed prior to calibration
when stage two calibration is complete.
215922
OPERATION
Figure 4.151: Calibration Screen
Figure 4.152: Calibration Screen
Figure 4.153: Calibration Screen
187
A
A
A
Revision A