Table of Contents
Advertisement
5. Remove hairpin (A) from pin (B), and remove pin (B) from
the header leg. Repeat this step on the opposite header leg.
DANGER
Ensure that all bystanders have cleared the area.
6. Start the engine.
7. If you are lowering the header lift legs WITH a header or
weight box attached to the windrower, proceed to
Step
11, page
169.
If you are lowering the header lift legs WITHOUT a header
or weight box attached to the windrower, fully release the
tension in header float springs (A):
• If prompted by the Harvest Performance Tracker (HPT)
to remove the float, then remove the float and proceed
to Step
11, page
169.
• If not prompted by the HPT to remove the float, then
proceed to Step
8, page 169
manually.
IMPORTANT:
When lowering the header lift legs without a header or
weight box attached to the windrower, ensure that the
tension on the float springs is fully released. This will
prevent damage to the header lift linkages.
215922
OPERATION
to remove the float
168
A
B
Figure 4.102: Header Leg
A
Figure 4.103: Header Float Springs
Revision A
Advertisement
Table of Contents
Troubleshooting
