MacDon M1170NT5 Operator's Manual page 140

IMPORTANT:
Before starting the windrower, check the levels of the following fluids, and add more if necessary:
• Engine oil – refer to
Checking Engine Oil Level, page 118
• Hydraulic oil – refer to
• Gearbox oil – refer to
5.7.7 Checking Engine Gearbox Lubricant Level and Adding Lubricant, page 275
IMPORTANT:
Do NOT tow the machine to start the engine. Damage to the hydrostatic drives will result.
NOTE:
When the windrower console receives a wake-up signal, the console awakens from sleep mode and closes the battery
disconnect relay. The Harvest Performance Tracker (HPT) goes into a boot-up sequence that takes approximately
40 seconds. The following items trigger a wake-up signal for the console:
• Key switch ignition or accessory positions
• Cab door switch
• Horn button
• Hazards button
• Field lights button
• Clearance lights button
• Road lights button
• High beam button
1. Before starting the engine, ensure that engine exhaust
pipe (A) is not covered or obstructed.
NOTE:
Before taking the GSL out of PARK, let the hydraulic oil
warm up to 32°C (90°F). You can view the hydraulic oil
temperature on Run Screen 4 on the Harvest Performance
Tracker (HPT) display. For instructions, refer to
Engine Cooling Data, page
215922
5.7.3 Checking Hydraulic Oil, page 272
Viewing
138.
OPERATION
A
Figure 4.12: Engine Exhaust
120
Revision A