MacDon M1170NT5 Operator's Manual page 244

To program a float setting for each of the deck shift positions, follow these steps:
1. Start the engine, and use HEADER TILT switches (A) and (B)
on the ground speed lever (GSL) to set header tilt to the
mid-range position.
2. Engage the header by pushing and holding HEADER
ENGAGE switch (A) down, and pulling up on collar (B).
3. Select one of the following deck positions using the DECK
SHIFT switches on the operator's console:
• Right-side delivery (A)
• Center delivery (B)
• Left-side delivery (C)
215922
OPERATION
B
Figure 4.238: GSL
Figure 4.239: Header Engage Switch
A
Figure 4.240: Header Deck Shift Switches
224
A
A
B
B
C
Revision A