MacDon M1170NT5 Operator's Manual page 194

5. Rotate left signal light placard (A) to the up (vertical)
position before connecting the hose management system.
6. Connect hydraulic hose management system (A) to the
windrower by securing ball joint (B) to latch support (C) on
the windrower leg.
7. Retrieve draper drive and reel control multicoupler (A) from
the hydraulic hose management system.
8. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
9. Open cover (D) and position the coupler onto the
receptacle. Align the pins in the coupler with the slots in
handle (C) and push the handle toward the windrower so
that the coupler locks onto the receptacle and knob (B)
pops out.
10. Remove hose quick-disconnect (F) from the storage
location and connect it to the receptacle on the frame.
NOTE:
Hose quick-disconnect (F) is only present on M1170NT5
machines with the R1 Series Hydraulic Drive kit
(MD #B6845) installed.
11. Remove the cover from electrical connector (E), push the
electrical connector onto the receptacle, and secure it by
turning the collar on the electrical connector clockwise.
215922
OPERATION
Figure 4.117: Left Signal Light Placard
Figure 4.118: Hydraulic Hose Management System
E
Figure 4.119: Draper/Reel Multicoupler
174
A
A
A
B
D
B
C
C
F
Revision A