3. Shut down the engine, and remove the key from the ignition.
4. Retrieve the transport harness from holder (A), located
behind the left platform, and connect it to electrical
receptacle (B).
5. Rotate left signal light placard (A) to the down (horizontal)
position before driving in narrow transport mode.
6. At the front of the windrower, rotate walking beam lockout
valve handle (A) to the open position (in line with the
valve).
7. Remove lockout pins (B) from the sliding drive wheel legs.
WARNING
Check to be sure all bystanders have cleared the area.
8. Ensure bystanders have cleared the area, start the
windrower, and set the idle to low.
215922
OPERATION
B
A
Figure 4.54: Transport Electrical Connector
Figure 4.55: Left Signal Light Placard
Figure 4.56: Transport Locks
145
A
A
B
Revision A