Table of Contents
Advertisement
7.10.4 Creating or modifying a program (Edit)
Here, there are the following functions:
Entry of a program.
Display of the program data of a saved program and modification of the segment data.
Insertion or appending of a new segment.
Deletion of a segment.
Entering a program:
Command
Status
Edit
Loops
Graph
Info
Pump
Menu
No.
T end °C
Start
30,00°C
1
30,00°C
Pump
Menu
64
In addition, when a program has just been executed, new segments can be inserted
and existing ones modified, even the currently active segment. Furthermore, all
segments, except the currently active one, can be deleted at any time.
Modifications to the currently running segment are possible. The segment then con-
tinues as though the modification had been applicable since the start of the seg-
ment.
However: If the new segment time is shorter than the segment time that has already
run, then the program skips to the next segment.
If a segment time >999h:59min is required, then this time must be shared over a
number of consecutive segments.
Modify
Delete
End
T
set
Time [h:m] Tolerance
-------
00:30
End
Insert
Proline Edition X heating thermostats
Program example ( 7.10.1).
Programmer
In the
Press the
Continue to
There is the possibility of modifying single
T
fix
In the "Start" line enter in the field "T end
3,00°C
3,00°C
Delete single segments (rows) with
For thermostats without cooling ability,
Delete
Starting up
Program1
Edit
menu one can
Delete
a program.
key.
Modify .
with the key
segments, i.e. segments can be entered
as new, changed and also deleted.
°C" the temperature at which the se-
quence is to start (default value is 30 °C).
A time entry is not possible in the "Start"
segment, because the thermostat imme-
diately executes Segment 1 on reaching
the start temperature.
Delete .
the setpoint temperature must be obtain-
able, i.e. above the bath temperature dis-
played at the time of the program start!
Edit
Modify
Modify
or
..
YACE0099 / 10/9/2018
Advertisement
Table of Contents
