Installing/Removing The Battery Pack For The Flat Panel Sensor - FujiFilm FDR ES DR-ID1270 Operation Manual

3.1.7 Installing/Removing the Battery Pack for the Flat Panel
Sensor
Follow the procedure below to install/remove the battery pack for the flat panel sensor.
When installing/removing the battery pack, place the flat panel sensor on a flat place.
Do not remove the battery pack until a processed image appears in the window of the image processing unit after
the exposure.
1
Remove the battery cover.
Place the flat panel sensor with the back side facing
upward and press the "●" portion of the lock lever.
3
Lock lever
Slide the lock lever in the direction of the arrow to
remove the battery cover.
2
Install the battery pack.
Slide the battery pack along the dent of the battery
section of the flat panel sensor toward the connector
terminal. Align the guide mark of the battery pack
with that of the flat panel sensor, and push the
battery pack in to install it.
Make sure that battery pack is securely installed.
3-6
DR-ID1270 Operation Manual 897N120821E
When installing the battery pack, do not press the
lock lever.
Pushing the battery pack in with the guide marks
misaligned may damage the connector terminal.
When attaching the battery pack, make sure that
the waterproof packing attached to the connector
terminal of the flat panel sensor is aligned
properly.
When the battery pack is installed in the flat panel
sensor, the power is automatically turned on.
Battery pack
•
To remove the battery pack, perform the same
1
procedure as Step (removing the battery cover).
•
To install the battery cover, perform the same
2
procedure as Step (installing the battery pack).
Guide marks Guide marks