Changing The Direction Of The Flat Panel Sensor Connector - FujiFilm FDR ES DR-ID1270 Operation Manual

[2] Bed type
When inserting the flat panel sensor
to the radiographic examination stand,
direct the exposure plane upwards.
1
Pull out the tray by using the handle.
3
2
Pull the cassette stopper, and set the flat
panel sensor so that its center mark is
aligned with the center of the stopper.
Cassette
stopper
Center mark

3.1.5 Changing the Direction of the Flat Panel Sensor Connector

The direction of the connector of the flat panel sensor can be changed, depending on how it is
inserted into the radiographic examination stand.
To change the direction, contact our official dealer or FUJIFILM Representative.
3-4
DR-ID1270 Operation Manual
CAUTIONS
Tray
When shipped After changing the direction
897N120821E
3
Push the tray back into place by using the
handle after setting the flat panel sensor.
4
Remove the flat panel sensor after use.
Hold the handle and pull out the tray. Remove the
flat panel sensor while pulling the cassette stopper,
and then push the tray back into place.