FujiFilm FDR ES DR-ID1270 Operation Manual page 15

Other Warnings and Cautions
WARNING
No modification of this equipment is allowed.
CAUTIONS
Install the system in accordance with what is provided by IEC 60601-1:2005 + A1:2012 Chapter 16.
Contact our official dealer or FUJIFILM Representative for installation (except the flat panel sensor)
of the system.
CAUTIONS
Do not hit or drop the equipment. Otherwise, injury or damage to images, etc. may result.
If the flat panel sensor is subjected to an impact, the internal sensor may also be damaged,
causing image artifacts, etc.
Artifacts may appear immediately after an impact is applied or after some time has passed.
CAUTIONS
Be sure to inspect the system periodically.
To assure optimum performance of the equipment, it is necessary to systematically perform
maintenance and inspection. For information on maintenance and inspection, contact our
official dealer or FUJIFILM Representative.
CAUTIONS
Do not perform maintenance and inspection while the equipment is used for a patient.
CAUTIONS
The institution where the equipment is installed is responsible for its use and maintenance.
In addition, this equipment should not be used by persons other than doctors or suitably
trained staff.
CAUTIONS
Be careful not to expose the flat panel sensor to X-ray without a subject.
CAUTIONS
Although the flat panel sensor conforms to IPX3, no warranty is given as to the prevention of
water intrusion in the flat panel sensor. If the flat panel sensor is splashed with water, wipe off
moisture and ensure that the flat panel sensor is completely dry before use.
CAUTIONS
Do not hit or scrape the flat panel sensor against sharp objects. If the damaged flat panel sensor
is continuously used, personal injury may result.
DR-ID1270 Operation Manual 897N120821E
1
1-9