Using The Se Storage Case - FujiFilm FDR ES DR-ID1270 Operation Manual

O.2 Using the SE Storage Case
CAUTIONS
● Do not store the SE storage case in a location with the following conditions.
● Where the SE storage case is exposed to direct sunlight.
● Where the temperature and humidity change dramatically.
● Where there is excessive dust.
● Where chemicals are stored.
● Where the SE storage case may be exposed to water due to water leakage or ingress.
● Store the flat panel sensor and the cable properly in the SE storage case.
Otherwise, they may be caught under the case lid and damaged.
● Do not connect the flat panel sensor to the SE cable or SE communication cable while it is
stored in the SE storage case.
● Do not store anything other than the flat panel sensor in the SE storage case.
● Carefully carry the SE storage case when the flat panel sensor is inside.
● The SE storage case and/or the flat panel sensor inside may be damaged if the case is
subject to an impact.
● Do not open/close the SE storage case in a location where there is excessive dust or dirt.
● Do not put the SE storage case on an unstable place. If it falls or drops, personal injury may
result.
● Be careful not to have your hand or an object caught when closing the SE storage case.
When storing the flat panel sensor in the SE storage case, place it with the exposure plane down.
For details, see the illustrations below.
SE storage case for 35
(DR-ID1271SE/DR-ID1273SE)
O-2
DR-ID1270 Operation Manual
SE storage case for 35
(DR-ID1271SE/DR-ID1273SE)
Battery holder
pockets
897N120821E
SE storage case for 43
(DR-ID1272SE/DR-ID1274SE)
SE storage case for 43
(DR-ID1272SE/DR-ID1274SE)
Battery holder
pockets