Access Point - FujiFilm FDR ES DR-ID1270 Operation Manual

O.5 Access Point
Precautions for Use
CAUTIONS
● The Access Point incorporates a wireless device that complies with the technical standards.
Do not disassemble or modify the Access Point.
In addition, do not remove the name plate attached to this product. If the name plate is not
attached, use of this product is prohibited.
● Use of the Access Point is allowed in the area of purchase.
● Make sure that there are no shielding materials between the Access Point and the communication
device. For example, if there is a metal plate or concrete wall between them, wireless
communication may not be available. In addition, do not cover the plane with the status lamps.
● Do not use the Access Point near the following devices.
- Industrial, scientific and medical equipment such as a microwave oven, pacemaker, etc.
- Local private radio stations for mobile object identification used in factory production lines, etc.
(radio stations requiring a license)
- Specified low power radio stations (radio stations requiring no license)
● Do not use the Access Point near radios, televisions, mobile phones or PHS phones as far as
possible. If these devices are placed near the wireless LAN products, audio or video noise may
occur due to electromagnetic waves generated from the wireless LAN products including the

Access Point.

● Do not use the Access Point near a heat source. In addition, do not cover the ventilation holes.
● Do not allow the Access Point get wet or dusty.
● Take care not to trip over the cable. If the cable is disconnected or almost disconnected,
wireless communication may not be established.
● Do not subject the Access Point to severe shock (by dropping it, etc.).
● When using the Access Point, place it at least 20cm (7.9in.) away from the body.
● To supply power to the Access Point, connect it to the FUJIFILM-specified personal computer
supporting USB 3.0.
● Use the Access Point by connecting it to the preset image processing unit and to the USB
connector.
● Directly connect the Access Point and the image processing unit only with the supplied USB
cable. Do not use a hub for connection.
● Do not delete or change the USB driver installed in the image processing unit.
● Do not place the supplied Velcro tape over the Access Point Product Label and Access Point
Radio Law Certification Label.
O-4
DR-ID1270 Operation Manual 897N120821E