Table of Contents
Advertisement
Precautions for LAN Connection
CAUTIONS
● For the LAN connection, use the dedicated LAN conversion cable. In addition, when connecting
or disconnecting the LAN conversion cable, be sure to hold the connector portion.
If it is connected or disconnected while holding the cable, the cable may be broken.
● Radio waves available outdoors vary, depending on the country where the system is used.
(For Canada)
Radio waves in the 5.2GHz and 5.3GHz frequency band can be used indoors only.
(For U.S.)
Radio waves in the 5.2GHz frequency band can be used indoors only.
● When radio waves in the 5.3GHz and 5.6GHz frequency bands are selected, the DFS function will
operate.
● When the Access Point and a personal computer is connected using the USB cable, do not
connect the Access Point and the personal computer via the LAN connection.
Precautions for Using the DFS (Dynamic Frequency Selection) Function
CAUTIONS
● The Access Point supports the DFS function conforming to IEEE 802.11n. When radio waves
in the 5.3GHz and 5.6GHz frequency bands are selected, the channel may be changed
automatically in order to avoid interference to weather radar, etc.
● Even during start-up, the Access Point checks if there are any radar waves. While the check is
in progress, communication with the Access Point is not available.
● If a radar wave is detected, the radar wave is monitored for a specified time (about 1 minute)*.
While monitoring the radar wave, wireless communication is not available. In addition, about 30
minutes are required until the channel in which a radar wave was detected becomes available.
* 10 minutes for the 120 to 128 channels in Europe
Lamps
POWER
LAN cable terminal
For details of the access point, see "Access point Operation Manual".
● Status lamp
WIRELESS
WSTAT
● Wireless LAN Switch
USB cable terminal
● Restart Switch
WLAN
ON/OFF
Switch
Reset Switch
POWER
Green
Blinks
Green
On
Red
Blinks
WIRELESS
Green
On
Orange
On
Off
WSTAT
Green
Data transmission in progress
Red
DFS is active
When wireless LAN is OFF:
Press and hold this switch for more than 3 seconds to turn
ON wireless LAN.
When wireless LAN is ON:
Press and hold this switch for more than 3 seconds to turn
OFF wireless LAN.
The Access Point restarts when this switch is pressed after
the Access Point starts up.
(Do not press this switch during the start-up process.
If pressed, wireless communication may not be established.)
DR-ID1270 Operation Manual
Start-up in progress
Start-up completed
USB communication error
5GHz band
2.4GHz band
Wireless LAN OFF
897N120821E
O-5
Advertisement
Table of Contents
