Mounting Of Implements To The Tractor Rll - Belarus 1523.5 Operator's Manual

4.3.3.5 Mounting of implements to the tractor RLL

While mounting of implements to the tractor, make sure that there are no people in the ar-
ea of implement mounting. Using RLL controls put down lower links to the required posi-
tion and connect lower links hinge joints to the implement, and then connect upper link
hinge joint by means of a pin. Use the right lifting rod to adjust the implement position in
transverse plane. To make adjustments in fore-and-aft plane for depth levelling of the im-
plement front and rear operating parts, change the upper link length by turning the link
pipe to the corresponding direction.
Final adjustment of the machine shall be made in the field.
Before starting operation, make sure that:
- tractor parts are not in dangerous closeness to implement elements;
- upper link does not touch the PTO guard with the implement in lowest position;
- cardan drive from PTO is not abnormally long, with bigger joint angles and there is no
thrust force;
- PTO guard does not touch the machine cardan drive guard;
- lift the implement slowly and check availability of clearances between the tractor and the
implement in upper position;
- check availability of the required side oscillation of lower links and adjust it by means of
buckles, if necessary.
WARNING: SOME TYPES OF MOUNTED OR SEMI-MOUNTED IMPLEMENTS CAN
TOUCH THE CAB AND DAMAGE IT. IT CAN RESULT IN DAMAGE OF THE CAB WIN-
DOWS AND CAUSE INJURY TO THE OPERATOR. CHECK AVAILABILITY OF CLEAR-
ANCES (AT LEAST 100 MM) BETWEEN THE UPLIFTED IMPLEMENT AND THE OP-
ERATOR`S CAB!
Mounting of machines (implements) to the tractor shall be carried out by means of auto-
matic coupler СА-1, connected to the tractor lift linkage in three points (two rear hinge
joints of lower links and a rear hinge joint of the upper link).
ATTENTION: AFTER COUPLING OF THE TRACTOR EQUIPPED WITH LINKS AND
GRIPPERS MANUFACTURED BY MTW, WITH MOUNTED OR SEMI-MOUNTED IM-
PLEMENTS, IT IS REQUIRED TO LOCK THE RLL LOWER LINKS GRIPPERS BY
MEANS OF PIN 1 (FIGURE 4.3.7a) WITH RING 2!
ATTENTION: WHILE DETACHING THE IMPLEMENT FROM THE TRACTOR, IT IS RE-
QUIRED TO REMOVE FROM THE IMPLEMENT AXLE 6 (FIGURE 4.3.7a) LINCH PIN 5
WHICH FIXES HINGE JOINT 4 ON THE IMPLEMENT AXLE 6, ALSO REMOVE PIN 1
WITH RING 2 FROM THE GRIPPER, THEN UPLIFT THE HANDLE OF GRIPPER 3
AGAINST THE STOP. SET THE PIN AND THE LINCH PIN AS SHOWN IN VIEW b) OF
FIGURE 4.3.7a!
a) the pin and linch pin position with the
implement coupled
1 – pin; 2 – ring; 3 – gripper handle ; 4 – hinge joint; 5 – linch pin; 6 – implement handle.
Figure 4.3.7а – Locking of the RLL lower links grippers
b) the pin and linch pin position with the
implement uncoupled
104
1523.5-0000010 OM