Upper Shield Unit Of Button Switches; Conditioner Control; Conditioner Control In The Conditioning Mode - Belarus 1523.5 Operator's Manual

Table of Contents

2.3 Upper shield unit of button switches

Pressing cut-out button 1 (fig 2.3.1) activates a flash beacon (if available).

Pressing cut-out button 2 activates two front working lights, mounted on the cab

roof, and an indicating lamp built in the button.

Pressing cut-out button 3 activates two rear working lights (inner) and an indicating

lamp built in the button.

Pressing cut-out button 4 activates two rear working lights (outer) and an indicating lamp

built in the button.

Pressing cut-out button 5 activates the rear screen wiper or the wiper and the washer of

the rear screen simultaneously.

Cut-out button 5 has three positions:

- position "I" – "off";

- position "II" – "rear screen wiper is on" – fixed position;

- position "III" – "rear screen wiper and rear screen washer are on simultaneously –

non-fixed.

During tractor operation on forward motion, cut-out switch 8 (fig. 2.1.1) shall be in "on" po-

sition (i.e. in the upper position).

Pressing cut-out button 6 (fig. 2.3.1) activates "Road-train" signal lights and an indicating

lamp built in the button (the "Road-train" lights are installed against order).

1 – flash beacon cut-out button; 2 – cut-out button of front working lights, mounted on the

cab roof; 3 – cut-out button of rear inner working lights; 4 – cut-out button of rear outer

working lights; 5 – cut-out button for rear screen wiper and washer; 6 – cut-out button of

"Road-train" signal lights.

2.4

Conditioner control unit 4 (figure 2.1.1) has switches 1 and 2 (figure 2.4.1).

2 – Conditioner cut-out switch and cooling capacity adjustment;

Figure 2.3.1 – Upper shield unit of button switches

1 – Switch for air flow adjustment;

Figure 2.4.1 – Conditioner control unit

1523.5-0000010 OM

Table of Contents