Lifting Rods - Belarus 1523.5 Operator's Manual

1523.5-0000010 OM
ATTENTION: WHILE PERFORMING TRANSPORT WORK, IT IS REQUIRED TO USE
THE SETTING "BUCKLE LOCKED"!
ATTENTION: WHILE TRACTOR OPERATION WITH THE MOUNTED IMPLEMENT OR
MACHINE, IT IS REQUIRED TO USE THE SETTING "BUCKLE LOCKED" OR "BUCKLE
UNLOCKED" ACCORDING TO THE INSTRUCTIONS OF THE OPERATOR'S MANUAL
ON COUPLED IMPLEMENTS (MACHINES) OPERATION!
IT IS NOT ALLOWED TO USE BUCKLE WITHOUT FIXING THE SLIDE PIECE ON THE
GUIDING PINS WITH A LINCH PIN!

4.3.3.2 Lifting rods

A lifting rod consists of a screw with hinge pivot 1 (figure 4.3.5), pipe 2, yoke 3, splint pin 4,
pin 5, washer 6, counter nuts 7.
Adjustment of the lifting rod length is carried out in the following order:
- unscrew counter nut 7;
- while rotating pipe 2 clockwise or counterclockwise, change the lifting rod length;
- adjust the lifting rod length and locknut the screw connection with counter nut 7.
While setting pin 5 into the upper hole of yoke 3 as shown in figure 4.3.5, the lifting rod
length shall be adjusted within 630 to 830mm.
During shipment from the works, pins 5 are mounted into the upper holes of yokes 3, lifting
rods are adjusted for the length of 780mm.
While setting pin 5 into the lower hole of yoke 3, the lifting rod length shall be adjusted
within 700 to 900mm.
Setting of the lifting rod shall be carried out in the following way:
while tractor operation with mounted and semi-mounted implements and machines (except
for wide-cut), RLL links shall not move freely in the lifting rod yokes. For this, pin 5 in the
lifting rod shall be fixed into one of yoke 3 holes. Setting of pins 5 on the left and right lift-
ing rod shall be equal;
while tractor operation with wide-cut mounted or semi-mounted implements, it is required
to fix pins 5 in lifting rods into the grooves (cut slots) "A" of yokes 3 to provide vertical
movement of lifting rods in relation to the lifting rod yoke. While setting pins 5 into the
grooves "A" of yokes 3, the lifting rods length shall be adjusted within 700 to 900mm.
1 – screw with hinge pivot assembly; 2 – pipe; 3 – yoke; 4 – splint pin; 5 – pin; 6 – washer;
7 – counter nut.
Figure 4.3.5 – Lifting rod
While operating with implements, adjust the right lifting rod length according to the soil
processing depth.
102