Information On The Tractor Mounting Holes - Belarus 1523.5 Operator's Manual

4.13.3 Information on the tractor mounting holes

The present subsection contains the information on availability of the tractor mounting holes which
can be used by manufacturers of front loaders for loader installation, and also by manufacturers of
tractors for installation of various equipment. The mounting holes arrangement scheme for tractor
"BELARUS-1523.5" is shown in figure 4.13.2. The parameters of mounting holes are listed in table
4.11.
Table 4.11 – Parameters of mounting holes of tractor "BELARUS -1523.5"
Designation № 1
Diameter М16
Length -
Designation № 6
Diameter М16
Length -
Designation № 11
Diameter М16
Length -
Designation № 16
18
Diameter
Length -
Designation № 21
Diameter М16
Length -
Designation № 26
Diameter М16
Length -
Designation № 31
Diameter М16
Length 23
Designation № 36
20
Diameter
Length -
Designation № 41
Diameter М22
Length 54
Designation № 46
Diameter М10
Length 15
Designation № 51
20
Diameter
Length 28
NOTES:
Sizes in table 4.11 are given in mm.
Holes 1...30 are right and left.
Holes 1...29 (odd numbers) are upper row.
Holes 2...30 (even numbers) are low row.
While installation of mounted elements, provide safety of bushings in holes 1, 6 and 14. It is not
recommended to use holes with bushings for coupling.
In table 4.11 the symbol "-"means a through hole.
Holes 27, 28, 29, 30 on the right side of the tractor are used for installation of the tank and muffler
brackets.
ATTENTION: IT IS NOT RECOMMENDED TO USE TRACTOR SIDE HOLES WITH BUSHINGS!
THE MOUNTED LOADER ELEMENTS SHALL NOT CAUSE BUSHING DAMAGE!
№ 2 № 3
М16 М16
20 20
№ 7 № 8
М16 М16
- -
№ 12 № 13
М16 М16
- -
№ 17 № 18
18 18
- -
№ 22 № 23
М16 М16
- -
№ 27 № 28
М16 М16
23 23
№ 32 № 33
М16 М16
23 -
№ 37 № 38
18 18
- -
№ 42 № 43
М22 М10
54 15
№ 47 № 48
М20 М20
40 40
№ 52 № 53
М20 М20
32 32
for installation of pins.
133
1523.5-0000010 OM
№ 4 № 5
М16 М16
- -
№ 9 № 10
М16 М16
- -
№ 14 № 15
18
М16
- -
№ 19 № 20
18 18
- -
№ 24 № 25
М16 М16
- -
№ 29 № 30
М16 М16
23 23
№ 34 № 35
20
М16
- -
№ 39 № 40
М22 М22
54 54
№ 44 № 45
М10 М10
15 15
№ 49 № 50
20
М20
40 28