Possible Failures In The Electronic Control System Of Rll And Instructions For Their Troubleshooting - Belarus 1523.5 Operator's Manual

1523.5-0000010 OM
6.12 Possible failures in the electronic control system of RLL and instructions for
their troubleshooting
Cables and control system of RLL connecting diagrams are shown in figures 6.12.1,
6.12.2. The rules of failure diagnostics of the RLL ECS are specified in clause "Trouble-
shooting of RLL electronic control system" of subsection 2.17 "Lift linkage controls". Possi-
ble RLL electronic control system error codes and instructions for their troubleshooting are
shown in table 6.12.
ATTENTION: DISCONNECTION OF THE ELECTRIC SOCKETS OF THE REAR LIFT
LINKAGE ELECTRONIC CONTROL SYSTEM SHALL BE CARRIED OUT WHEN THE
ENGINE IS NOT RUNNING ONLY!
ATTENTION: ALTERATIONS OF THE SPECIFIED VOLTAGE VALUES SHALL BE DONE
WITH THE ENGINE RUNNING, WITH DUE ATTENTION TO THE SAFETY MEASURES
IF OPERATING WITH ELECTRIC UNITS ON LOAD!
ATTENTION: TERMINALS IN THE CABLE SOCKETS ARE NUMBERED ON THE
SOCKETS SHELLS!
ATTENTION: REPAIR OPERATIONS OF THE REAR LIFT LINKAGE AND FRONT LIFT
LINKAGE ELECTRONIC CONTROL SYSTEM SHALL BE CARRIED OUT ONLY BY
DEALERS. OTHERWISE THE WARRANTY FOR THE REAR LIFT LINKAGE AND
FRONT LIFT LINKAGE CONTROL SYSTEM BECOMES INVALID!
193