Start-Up And Operation; Maintenance - KEB COMBIVERT F6 Instructions For Use Manual

WARNING
WARNING
DANGER
ma_dr_f6-cu-k-inst-20144795_en
– When using components without isolated inputs/outputs, it is necessary that
equipotential bonding exists between the components to be connected (e.g. by
the equipotential line). Disregard can cause destruction of the components by
equalizing currents.

2.2 Start-up and operation

The start-up (i.e. the starting of normal operation) is prohibited until the machinery
has been proved to conform to the provisions
2014/30/EU; EN 60204-1
Wrong parameterization
Unintentional behaviour of the drive
ü During initial start-up or replacement of the drive controller
a) Secure motors against automatic restart.
b) Check whether the appropriate parameter list for the application has been im-
ported.
Software protection functions as sole protection.
Protection function in case of software problems without function.
ü Securing a unit solely with software-supported functions is not sufficient.
a) Install external protective measures (e.g. limit switch) that are independent of
the drive controller.

2.3 Maintenance

Unauthorized exchange, repair and modifications
Unpredictable malfunctions
a) The function of the drive controller is dependent on its parameterization. Never
replace without knowledge of the application.
b) Modification or repair is permitted only by KEB Automation KG authorized per-
sonnel.
c) Only use original manufacturer parts.
d) Infringement will annul the liability for resulting consequences.
General Safety Instructions | 2
Directive 2006/42/EG
must be observed.
and Directive
11