Initial Start Up; Connecting The Drive And Operator; Default Operator And Drive; Previously Programmed Operator Or Drive - KEB COMBIVERT F5 Operation Manual

4. Initial Start Up

4.1. Connecting
the drive and
operator

4.1.1. Default Operator
and Drive
4.1.2. Previously
Programmed
Operator or Drive
The drive and operator must be "synched" before being able to operate.
When the operator/drive are initially booted up, the parameters of each are
compared and it is determined if the units are synched. If they are not, the
user will be given programming options.
A drive/operator will not be synched under the following conditions:
• A default drive and/or operator is being installed
• The operator was used to program another drive.
If the drive and operator are default the user will be prompted to program
the drive manually. See the next section 5.2 for manual programming.
If either the drive or operator have been programmed previously, the user
will be given three options: 1. Copy operator to drive, 2. Copy drive to opera-
tor or 3. Manual program.
Copy operator to drive (Previously Programmed Operator):
1.
Install the operator keypad, the boot sequence will begin and the display
will indicate that the settings between the drive and operator do not match
and that they are not synchronized; press the ENTER button to proceed.
2.
Press the F1 button under "Dnld" . The operator parameters will be down-
loaded to the drive.
3.
Once the process is complete, the home screen will be displayed. The
mode window will display "idle" and the Ready / Stop / Error light will be
green to indicate that the drive is ready for operation.
Initial Start Up
67