Figure 3-6: Mx15-1 Output Wiring (Rear View) - Ametek California Instruments MX15 Series User Manual

Output Terminal Blocks
The MX15-1 and the MX15-1Pi have one output terminal block. The terminal block is large
enough to accommodate the recommended wire gauge sizes shown in Table 3-2. The terminal
block is located in the lower left corner on the rear of the unit. The rear panel needs to be
removed to access this terminal block.
CAUTION:
The correct standard size Allen wrench for connecting output wiring to TB1 is supplied with each
MX15 in the ship kit. Look for a brown envelope. If the correct tools cannot be found, contact
AMETEK Programmable Power customer service at
Terminal 2 of TB1 provides the output LO connection, and terminal 1 of TB1 provides the output
HI connection. The location of TB1 is shown in Figure 3-2.
3.6.2 MX15-1, MX15-1Pi Output Wiring Diagram
Figure 3-6 shows the required output connections for a MX15-1 and MX15-1Pi (rear-view
perspective).
Always disconnect all input power from the MX before removing the rear panel cover that
provides access to the input and output terminal connections.
MX15 Series
REMOVE ALL INPUT POWER TO THE MX15 BEFORE REMOVING
THE REAR PANEL.

Figure 3-6: MX15-1 Output Wiring (Rear view)

service@programmablepower.com .
41