Ametek California Instruments MX15 Series User Manual page 16

2.1.4 DC Measurements
Parameter
V oltage
Current
Power
Note: A ccuracy specifications are valid above 100 counts. For current and power measurements, specifications apply from
2% to 100% of measurement range.
2.1.5 Harmonic Measurements (Pi controller)
Parameter
Frequency fundamental
Frequency harmonics
Phase
V oltage
Current
Note: A ccuracy specifications are valid above 100 counts. For current and power measurements, specifications apply from
2% to 100% of measurement range.
2.1.6 System Specification
Parameter
External M odulation:
Synchronization Input:
Trigger Input:
Trigger Output:
Function Strobe:
Output Status:
Non volatile memory
storage:
W aveforms
Transients
IEEE-488 Interface:
RS232C Interface:
16
Range
0 - 400 V olts
0 - 400 A mps
0 - 10 kW
Range
16.00 - 820 Hz
32.00 Hz – 16 K Hz
0.0 - 360.0°
Fundamental
Harmonic 2 - 50
Fundamental
Harmonic 2 - 50
0 to 10%
Isolated TTL input for external frequency control. Requires 5V at 5 mA for logic high.
External trigger source input. Requires TTL level input signal. Triggers on negative edge.
Response time 80 - 100 µs.
Programmable through transient list system. 400 µs pulse for voltage or frequency change.
Isolated TTL output. Output reverts to Function strobe when not used as Trig Out. This
function is mutually exclusive with the Function Strobe output.
A ctive for any voltage or frequency program change. 400 µs pulse for voltage or frequency
change. Isolated TTL output. This function is mutually exclusive with the Trigger Output.
Same output is used for Trigger Output if Trigger Output is programmed as part of list
system.
M onitors status of output relay. Isolated TTL output. High if output relay is closed, low if
output relay is open.
16 complete instrument setups and transient lists, 100 events per list.
Sine (M odels with Standard controller)
Sine, square, clipped, user defined (M odels with Pi controller)
V oltage: drop, step, sag, surge, sweep
Frequency: step, sag, surge, sweep
V oltage and Frequency: step, sweep
SH1, A H1, T6, L3, SR1, RL2, DC1, DT1
IEEE 488.2 and SCPI
Response time is 10 ms (typical)
Bi-directional serial interface
9 pin D-shell connector
Handshake: CTS, RTS
Accuracy (±)
0.5 V olts
0.5 A mps
30 W
Accuracy (±)
0.03% + 0.03 Hz
0.03% + 0.03 Hz
2° typ.
0.75V
0.75V + 0.3% + 0.3%/kHz
0.5A
0.15A + 0.3% + 0.3%/kHz
Specification
Resolution
0.1 V olt
0.01 A mp
10 W
Resolution
0.01 Hz
0.01 Hz
0.5°
0.01V
0.01V
0.1A
0.1A