Table of Contents
Advertisement
ENTRY
SY STEM
A DV ANCE
CLOCK /LOC
M IL704
DO160
M S704
A BD
LF
M B
4.2.13 Elapsed Time and Temperature Screen
The Etime/Temp screen displays the elapsed time since the power source has first been turned
on. This is an accumulated total time in hours, minutes and seconds.
The same screen also displays the internal temperature of the power supply.
ENTRY
ETIM E
TEM P
86
DESCRIPTION
Shows model number.
ON
Designates the advanced measurement and arbitrary
waveform capability (-1Pi).
N/A
This feature is not available on –1 models. N/A is shown.
N/A
Clock and lock is an option. If no –LK M option is installed, this
field will show N/A .
M A ST
-LK M Option installed. The unit can be used as a Clock and
Lock system master or stand-alone.
A UX
-LK S option installed. The unit can be used as a Clock and Lock
system auxiliary or stand-alone.
A vionics test - M IL-STD 704 revs D and E Option (as
interpreted by A M ETEK at time of release)
A vionics test – RTCA DO160 Option
A vionics test - M IL-STD 704 revs A through F Option (according
to A ppendix A released with rev F)
A vionics test – A irbus A BD0100.1.8 Option
Low Frequency Option – Frequency will be limited to 500Hz
M ulti-Box Option – Each M X 15 in a multibox configuration will
have its own controller.
DESCRIPTION
01:23:45
The ETIM E field displays the total accumulated elapsed time
for the instrument since it's initial manufacture. This value
cannot be changed or reset.
37.342°
The TEM P field is not a user selectable parameter but rather a
read-out of the internal temperature in degrees Celsius. It is
provided for informational purposes only.
Advertisement
Table of Contents
