Figure 3-13: Usb Connector Pin Orientation; Table 3-9: Usb Connector Pin Out - Ametek California Instruments MX15 Series User Manual

3.7.6 USB Interface
A standard USB Series B device connector is located on the rear panel for remote control. A
standard USB cable between the AC Source and a PC or USB Hub may be used.
Note: Use of the USB port to control more than one power source from a single PC is
not recommended, as communication may not be reliable. Use GPIB interface for
multiple power source control.
Pin
1
2
3
4
MX15 Series

Figure 3-13: USB Connector pin orientation.

Name
V BUS
D-
D+
GND

Table 3-9: USB Connector pin out.

Description
+5 V DC
Data -
Data +
Ground
51