Ametek California Instruments MX15 Series User Manual page 82

ENTRY DESCRIPTION
address. To set the unit to DHCP mode, press SET and enter all
zeros (0.0.0.0) as the IP address and cycle power two times.
The obtained IP address will be displayed after the second
power on.
A ny change to this value will NOT take effect until after power
on the unit has been cycled.
W hen changing mode from static IP to DHCP, it is necessary to
cycle power on the unit twice, once to change mode and again
to obtain and display a new IP address from the network.
M A C A ddress Displays the network M edia A ccess Control address. This value
is fixed and cannot be changed. The same M A C is normally
printed on the model serial tag. The M A C address is shown as
six hexadecimal numbers separated by a colon, e.g.
02:20:4A :9A :02:FD. Note that the leading '0' is never visible
due to the maximum number of LCD characters per line.
GW A ddress Gateway address setting. A default gateway is a node (a
router) on a computer network that serves as an access point
to another network.
This value can be changed by pressing the SET key and
entering a new value from the keypad. Use the numeric data
pad to enter each field. To move between the four fields, use
the decimal point key on the keypad.
A ny change to this value will NOT take effect until after power
on the unit has been cycled.
HostBits Number of host bits as opposed to network bits in network
mask. A CIDR class C network uses 24 network bits and 8 host
bits. (Class A = 24, Class B = 16).
This value can be changed by pressing the SET key and
entering a new value from the keypad. A ny change to this
value will NOT take effect until after power on the unit has
been cycled.
Port No TCP remote port number. This value must be set to 5025
(SCPI) to support the built-in web page.
This value can be changed by pressing the SET key and
entering a new value from the keypad. A ny change to this
value will NOT take effect until after power on the unit has
been cycled.
LA N Default LA N default setting can be achieve by selecting the M ac
address screen and press the set key followed by the Enter
key. Press the Enter key again to confirm. The IP address is set
to DHCP or A UTO IP.
82