Table of Contents
Advertisement
The above tests can be selected by scrolling to the highlighted selection using the up and down
key and the ENTER key to start the selected test. For some of these tests, numeric data entry
may be required to define the test number or the modulation rate.
VOLT FREQ MIN
Standard/Group
V oltage
Frequency
Standard/Group
Standard/Group
V oltage
Frequency
Standard/Group
This test will set the voltage and frequency to levels defined by Table 9-1. The test will last for 30
minutes. The test will be repeated, except group1, using the Voltage setting from Table 9-2 and the
frequency from Table 9-1. The ← key (backspace) will terminate the test at any time.
VOLT FREQ MAX
This test will set the voltage and frequency to levels defined by Table 9-2. The test will last for 30
minutes. The test will be repeated, except group1, using the Voltage setting from Table 9-1 and the
frequency from Table 9-2. The unselected phases will remain at 115 volts. The ← key
(backspace) will terminate the test at any time.
MX15
Phases
RTCA
1
100
3
N/A
380
Phases
V oltage
1
3
Frequency
Table 9-1: Normal Voltage and Frequency minimum
Phases
RTCA
1
122
3
N/A
420
Phases
V oltage
1
3
Frequency
Table 9-2: Normal Voltage and Frequency Maximum
A(CF)
A(NF)
100
100
N/A
N/A
390
360
Group1
Group2
Group3
104
104
N/A
N/A
390
360
A(CF)
A(NF)
122
122
N/A
N/A
410
650
Group1
Group2
Group3
122
122
N/A
N/A
410
650
A(WF)
100
N/A
360
104
N/A
360
A(WF)
122
N/A
800
122
N/A
800
137
Advertisement
Table of Contents
