Unpacking And Installation; Unpacking; Power Requirements; Figure 3-1: The Mx15 Power Source - Ametek California Instruments MX15 Series User Manual

3 Unpacking and Installation

3.1 Unpacking

Inspect the unit for any possible shipping damage immediately upon receipt. If damage is
evident, notify the carrier. DO NOT return an instrument to the factory without prior approval.
Do not destroy the packing container until the unit has been inspected for damage in shipment.
If possible, retain the container (wooden crate) in the event the system ever has to be returned
to the factory for either repair or upgrades
WARNING:

3.2 Power Requirements

The MX Series power Source has been designed to operate from a three-phase, three wire
(Wye or Delta) AC input line. A protective earth connection is required as well. (PE).
Available three-phase input settings are 208 V
(option -400), 440 V
CAUTION:
32
This power source weighs approximately 600 lbs / 272
Obtain adequate help when moving the unit. Make sure the
location (floor) in which the MX Series unit(s) will be installed
can support the weight of the unit(s).
(option -440), or 480 V
LL

Figure 3-1: The MX15 Power Source

Do not connect 400, 440, or 480V into a unit set for 208 or
230V unit, the result could be a severely damaged unit.
(option -208), 230 V
LL
(option -480).
LL
.
Kg
(option -230), 400 V
LL LL