Table 3-3: System Interface Connectors; Table 3-4: Analog Interface Connector - Ametek California Instruments MX15 Series User Manual

P8 / P9
28 CSB:
29 N/C
30 FLT B:
31 N/C
32 DC:
33 INP OFF: Input power control
34 A ERR HI: Error Signal Phase A , high
35 N/C
36 B ERR LO: Error Signal Phase B, low (Not Used)
37 C ERR HI: Error Signal Phase C, high (Not Used)
3.7.2 Analog Input Connector
Input screw-terminal strip. Functions are called out on rear panel decal. Table shows
connections from left to right when standing at the rear of the MX15 cabinet.
Pin
1 RPV HI. INPUT: A nalog input for External Modulation
2 RPV Lo.
3 EX T SY NC HI
4 EX T SY NC Lo
5 RI:
6 RI:
48
Current Sum Phase B. (Not Used)
A mplifier Fault Phase B (Not Used)
DC mode control

Table 3-3: System Interface Connectors

INPUT: return.
INPUT: A nalog input for external sync mode.
INPUT: return.
INPUT: Remote Inhibit. (See paragraph 3.12.)
INPUT: return.

Table 3-4: Analog Interface Connector

Description
Description