Formatting The Display - HEIDENHAIN QUADRA-CHEK ND 1100 Operating Instructions Manual

Setup | Formatting the display
11.11

Formatting the display

The Display menu contains fields and parameters for configuring display options.
Display menu options:
Startup linear units of measure
Startup angular units of measure
Selection of a comma or decimal
point radix
Unit of angular measurement for the
current session
To configure the display settings:
Highlight the Display menu
Highlight the Startup Linear parameter
Press a soft key to specify the unit of linear measure set on power-up
Startup Linear options:
MM - linear unit of measure set to millimeters
Inch - linear unit of measure set to inches
- linear unit of measure set to the last unit of measure used before the
Last
product was powered-off
Highlight the Startup Angular parameter
Press a soft key to specify the unit of angular measure set on power-up
Startup Angular options:
DD - angular unit of measure set to decimal degrees
- angular unit of measure set to degrees, minutes, seconds
DMS
Last - angular unit of measure set to the last unit of measure used before
the product was powered-off
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018
Display of large fonts
Selection of input axis
Resolutions for linear and angular
measurements
Position of axis displayed on DRO
screen
11
93