Table of Contents
Advertisement
11
Highlight the Radix parameter
Press the Decimal or Comma soft key to select a radix
Highlight the Current Angular parameter
Press the Decimal Degrees DD or Degrees/Minutes/ Seconds DMS soft key to
select the angular unit of measure
Highlight the Large Fonts parameter
Press the Yes or No soft key to enable or disable the display of large fonts on
the DRO screen
Highlight the Input Axis parameter
Press a soft key to select an axis
Highlight the MM Disp Res field
Enter the display resolution index number.
An index number of 0.001 will round the display of millimeters to 3 digits to the
right of the radix character.
Highlight the Inch Disp Res field
Enter the display resolution index number.
An index number of 0.001 will round the display of inches to 3 digits to the right
of the radix character.
Highlight the DMS Disp Res field
Enter the Degree/Minutes/Seconds index number.
An index number of 0.01 will round the display of 30°20'45" to 30°21'.
Highlight the DD Disp Res field
Enter the Decimal Degrees index number.
An index number of 0.01 will round the display of 30.786 degrees to 30.79
degrees.
Highlight the Display As parameter
Press a soft key to select the position the axis is displayed on the DRO screen
Axis position one is displayed at the top of the display. Subsequent axes are
displayed in order below position one. The positions of other axes are automatically
updated when the position of an axis is changed in the Display As field.
Press the finish key
The parameters are saved and the Setup menu is displayed
94
The Input Axis field is used to select the axis for setting the Display
Resolution and Display As settings listed below the Input Axis field.
Select each Input Axis individually and specify the settings for Display
Resolution and Display As for all axes.
Setup | Formatting the display
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018
Advertisement
Table of Contents
