Table of Contents
Advertisement
8
8.1
Overview
The product can perform simple linear or angular displacement measurements
such as a distance between points or an angle of rotation. The product can also
store values to measure cumulative minimum and maximum displacements for
touch-probe or crosshair measurements, such as shaft runout.
8.2
Linear and angular measurements
To perform linear or angular measurements:
Move the stage to target the start point for the measurement
Zero or preset the axes datums using the axis keys or the Preset soft key
Move the stage to target the point to be measured or rotate to the angle to be
measured
The measurement results will be displayed on the DRO screen and can be
output to a printer or a computer
Further information:
Further information:
Repeat for each axis of measurement
54
The instructions assume that the system is properly connected and that
any necessary measurement or display adjustments have been made
to meet the requirements of the user. Each set of instructions will begin
at the DRO screen where the current positions of axes encoders are
displayed.
Values on screens shown in the instructions are only examples, not
actual measurements.
"Printing data", Page 58
"External operation", Page 60
Measuring | Overview
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018
Advertisement
Table of Contents
