Encoders Menu - HEIDENHAIN QUADRA-CHEK ND 1100 Operating Instructions Manual

11
11.7.2

Encoders menu

The Encoders menu configuration fields include:
Input Axis selection
Radius and Diameter display
Encoder resolution
Teach amount
Scale counts
Encoder type
To configure encoder settings in the Encoders menu:
Highlight the Encoders menu
Highlight the Input Axis parameter
Press a soft key to select the desired axis
Highlight the Rad/Dia parameter
Press the Yes soft key to enable the axis to display radius or diameter
measurements
Or
Press the No soft key to disable Rad/Dia
When Rad/Dia is active the Rad or Dia soft key will be added to the bottom of
the DRO display
Further information:
Highlight the Res field
Enter the encoder resolution in the units shown in the Units parameter
80
Reference mark selection
Machine zero offset
Reversing encoder count direction
DRO label
Units of measure
"Selecting radius or diameter measurement", Page 50
Setup | Configuring encoders
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018