Adjusting The Display Contrast; Selecting A Unit Of Linear Measure - HEIDENHAIN QUADRA-CHEK ND 1100 Operating Instructions Manual

Preparing to measure | Establishing a repeatable machine zero
Establishing a machine zero without encoder reference marks
To establish a repeatable machine zero without encoder reference marks:
Move the stage to the hard-stop reference position for an axis
Press the enter key
Repeat for each axis
Error correction data that might be stored in the device will not be
applied if the requirement to cross reference marks is bypassed by
pressing the cancel key.
7.3

Adjusting the display contrast

The display contrast can be adjusted using the . (decimal) and +/- (plus/minus)
keys located on the numeric keypad.
To adjust the display contrast:
Press the . key to increase the contrast
Or
Press the +/- key to decrease the contrast
7.4

Selecting a unit of linear measure

To select a unit of linear measure:
Press the MM/IN soft key to toggle between millimeters and inches
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018
7
49