Overview; Mounting On The Stand - HEIDENHAIN QUADRA-CHEK ND 1100 Operating Instructions Manual

4
4.1

Overview

This chapter contains all of the information necessary for mounting the product.
4.2

Mounting on the stand

1
1 Cap screw
2 Lock washer
3 Washer
4 Washer
Shoulder screw
5
To attach the device to the stand:
Attach the unit to the stand as shown in the diagram above
Partially tighten the cap and shoulder screw
Adjust the device to the desired tilt position
Completely tighten the cap and shoulder screws
28
The following steps are only to be performed by qualified personnel.
Further information: "Personnel qualification", Page 19
4
2 3
5
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018
Mounting | Overview