HEIDENHAIN QUADRA-CHEK ND 1100 Operating Instructions Manual page 100

11
Format
METRO-C
Press the enter key
Highlight the Show Edge field
Enter the number of seconds to display the axis value when an edge is found
Highlight the Probe Dir field
Enter the number of counts used to determine the direction of travel for
an axis and external edge. The product will know which direction to apply
compensation when the edge location needs to compensate for external edge
size.
Highlight the Probe Diameter field
Enter the diameter of the probe
Highlight the Prt Update DRO parameter
Press the Yes or No soft key to enable or disable updating the DRO to show the
current location when data is sent to a computer or printer
Highlight the Probe Type parameter
Press the Standard or KT130 soft key to select a probe type
Highlight the Invert Probe parameter
Press the Yes or No soft key to enable or disable inverting the probe
Press the finish key
The parameters are saved and the Setup menu is displayed
100
Description
Each axis is printed as 7 digits without a decimal point.
Data:
X = 1.245
Y = -30.506
Z = 0.010
Q = 25.401
Printed:
+0001245-0030506+0000010+0025401+0000017
Setup | Formatting printed data
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018