HEIDENHAIN QUADRA-CHEK ND 1100 Operating Instructions Manual page 45

Basic operation | Menus
Extra menu
The Extra menu is used to perform measurement and data transmission functions.
To open the Extra menu:
Press the Menu soft key
Press the Extra soft key
Function
DMS/DD
Zero
Zero 2
Send X
Send Y
Send Z
Send Q
Send 2
Send 3
Send 4
Cl Datums
MinMax
Preset!
MCS
POE 0/1
+- Axis
FastOut
HEIDENHAIN | ND 1100 | Operating Instructions | 05/2018
Description
Toggles between the display of degrees, minutes, seconds and
decimal degrees
Zeros the X axis in the current datum
Zeros the X and Y axes in the current datum
Sends current X axis values to a computer or a serial printer via
the RS-232 port
Sends current Y axis values to a computer or a serial printer via
the RS-232 port
Sends current Z axis values to a computer or a serial printer via
the RS-232 port
Sends current Q axis values to a computer or a serial printer via
the RS-232 port
Sends current X and Y axes values to a computer or a serial
printer via the RS-232 port.
Sends current X, Y and Z axes values to a computer or a serial
printer via the RS-232 port.
Sends current X, Y, Z and Q axes values to a computer or a
serial printer via the RS-232 port.
Prompts for verification to clear all datums and sets the unit to
machine zero coordinates.
Collects and stores minimum and maximum values until the
FINISH key is pressed.
Applies last preset value to current position.
Prompts for verification to clear all datums and prompts to re-
establish machine zero coordinates.
Turns the Print On Edge function on or off.
Reverses the axis count direction.
Sets the product to RS-232 data streaming mode.
6
45