Touch Screen Installation - Barco FSN Series User Manual

5.
qçìÅÜ=pÅêÉÉå=fåëí~ää~íáçå
The figure below illustrates a simplified rear view of the Touch Screen and the supplied
desk stand. Use this figure for reference during the following procedure.
VESA Mounting
Touch Screen
Connector Panel
Figure 4-2. Touch Screen and Desk Stand
Use the following steps to install the Touch Screen and desk stand:
1.
2.
FSN Series • User's Guide
Connect the supplied AC Power Cord to the AC connector on the rear of the
Control Panel, and then to an AC outlet.
Note Connect the Control Panel to a properly rated supply circuit.
Refer to the
on page 102 for details.
Plate
Screw
Holes
Using the supplied screws, attach the VESA mounting plate to the rear of the
Touch Screen.
Thread the supplied cable harness through the cable access hole in the desk
stand. Ensure that the end with the large USB connector points towards the
Touch Screen. Be sure to leave an ample service loop.

Touch Screen Installation

"Power Cord/Line Voltage
4. Installation
Selection" section
Kensington Security
Slot
Lock Knob
Cable Access
Cable Mounts
95