Table of Contents
Advertisement
Installation
Unpacking
Carefully unpack the SDI-DMX Mixer Pro the verify that it arrived complete
and without any damage. If you do find damage, you must notify both the
shipping agent and your sales agent immediately.
Do not discard the shipping carton and packing materials. The carton and
packing materials are specifically designed to protect the product during
transport. High End Systems assumes no responsibility for products
damaged during transport. Any product being returned for repair must be
shipped in its original shipping carton and packing materials.
NOTE: Before sending anything to the factory, be sure to call your HES
dealer/distributor for a Return Authorization (RA) number. The
factory cannot accept any goods shipped without an RA number.
Hardware Installation
DMX Link
Power
Connecting the Video Inputs and Outputs
• Connect the SDI sources to the unit via the four BNC connectors.
• Connect the SDI outputs to the unit via the four BNC outputs.
• Connect the power connector and power up the unit.
When an input receives a video signal, the corresponding "Video Present"
LED will illuminate on the front of the unit. This lets you verify that the
video source equipment is operating correctly.
NOTE: This unit is not a standards converter so all input and output
devices must be of the same video standard, either 625 line - PAL
or 525 line - NTSC. You can "force" a video standard for an output
using menu commands, see SYSt (Set Standard) on page 9.
SDI-DMX Mixer Pro User Manual
Video Inputs
Video Outputs
RS232
3
Advertisement
Table of Contents
