Barco FSN Series User Manual page 249

Use the following steps to set the output V-Lock mode and SDI output timing, if
desired.
6.
7.
FSN Series • User's Guide
Note Remember that this mode can only be set when the
Reference Input is set to External .
Press the {Output V-Lock} button to toggle the Output V-Lock mode on or off.
~
When On , the {SDI Output Timing} button appears. All native inputs
are forced to Frame Sync mode, and one frame of delay will be incurred
on all native inputs. In addition, on the Input Setup Menu , the {Sync
Mode} button is grayed out.
~
When Off , you can not set H and V offsets, and the {Sync Mode} button
is active on the Input Setup Menu . This mode provides the least
amount of delay through the switcher.
Important When {Output V-Lock} is
and DSK Fill inputs on screen will change.
•
•
Refer to the "
for User Preference Setup instructions.
If {Output V-Lock} is On , press {SDI Output Timing} to set SDI H and V offsets.
Use the {SDI H Offset} and {SDI V Offset} controls to set the offsets as desired.
Reference Video and Output Setup
On , the position of the DSK Cut
If the user preference " Black on Invalid Video " is
turned on, the DSK turns off — because of the change
in output timing.
If the user preference " Black on Invalid Video " is off,
the DSK will be visible — but in a shifted position. In
this condition, the video position can be adjusted by
changing the output timing of the DSK source itself.
User Preference Setup
6. System Setup
" section on page 260
249