Barco FSN Series User Manual page 287

^ìíçã~íáÅ=táéÉ
Use the following steps to perform an automatic mix:
1.
2.
3.
4.
Please note the following important points regarding wipes:
•
•
tçêâáåÖ=ïáíÜ=hÉóë
A Key is a transition in which one video signal is superimposed over a background video
KEY signal. One signal "cuts" the hole in the background, and another signal "fills" the hole.
1
KEY
2
DSK
Please note:
•
•
The following topics are discussed in this section:
•
•
•
•
•
•
FSN Series • User's Guide
In the Next Transition Group , press BG .
On any PST bus, press the button for the desired "next" source. Use the SHIFT
button if required to select a shifted source. Remember that on the PGM bank,
the M/E (re-entry) button can be preset in the same way.
Press WIPE .
Press AUTO TRAN .
You can also press ALL TRAN (in the Custom Control Section ) to perform a
wipe on all buses simultaneously.
Remember that there are a wide variety of auto-transition combinations available
to you. Refer to the " Automatic Transitions
Prerequisites
~
Ensure that you are familiar with the Keyer Menu . In Chapter 5, refer to
the " Keyer Menu
~
If you are using linear keys, ensure that the key cut and fill signals are
properly mapped. In Chapter 5, refer to the "
section on page 210.
Using the buttons in the Next Transition Group , a variety of transitions are
possible with full lookahead:
~
Cut key on/off
~
Mix key on/off
~
Wipe key on/off
Using the buttons in the Direct Key Control Group , two transitions are possible
without lookahead:
~
Cut key on/off
~
Mix key on/off
Key Setup
Manual Mix Key
Automatic Mix Key
Manual Wipe Key
Automatic Wipe Key
Direct Control Keys
" section on page 280 for details.
" section on page 143.
7. Operations
Working with Keys
Map Buttons Menu "
287