Table of Contents
Advertisement
16. Save system configuration — After completing all "system" setups, save the
17. Set up Aux bus routes — As required, set up all Aux bus routes to peripheral
18. Set up transition rates — As required, set up all transition rates for all banks and
19. Set up wipes — Select the desired wipe patterns, and adjust direction and border
20. Set up keys — Select the desired key sources, and adjust type, fill, clip, gain and
21. Set up memory registers — Set up the desired "looks" for your show, and store
22. Ready to roll — With all output, input and system configurations saved, and all of
FSN Series • User's Guide
configuration and back up the system.
~
Chapter 6, "
Saving the Setup
~
Chapter 6, "
Backing up the System
destinations. ("
Working with Aux Buses
FTB. ("
Setting Transition Rates and Curves
type. ("
Working with Wipes
opacity as required. ("
Working with Keys
them in memory registers as required. ("
page 291.)
your important "looks" stored in memory, put on your headsets and get busy!
Note
For detailed system operating procedures, specific system
"tweaks" and operating descriptions on every feature, please
start with the "
page 266, and select the function that you wish to perform.
Quick Setup and Operations
," page 261.
," page 262.
," page 299.)
," page 284.)
," page 286.)
," page 287.)
Working with Memory Registers
Quick Function Reference
7. Operations
,"
" section on
265
Advertisement
Table of Contents
