Barco FSN Series User Manual page 45

13) DSK Cut In
14) DSK Fill in
15) Native Aux Outputs
FSN Series • User's Guide
One BNC is provided for a dedicated DSK Cut Input. The DSK Cut and DSK Fill
inputs must be locked to the FSN-1400 video reference within ± 0.5 lines, when
the {Output V-Lock} button is turned off (on the Reference and Output Setup
Menu). See the DSK Fill In description below for an important note.
One BNC is provided for a dedicated DSK Fill Input. The DSK Cut and DSK Fill
inputs must be locked to the FSN-1400 video reference within ± 0.5 lines, when
the {Output V-Lock} button is turned off.
Important When the {Output V-Lock} button is turned on (on the
Reference and Output Setup Menu), the position of the
DSK Cut and DSK Fill inputs on screen will change.
•
•
In Chapter 5, refer to the
on page 217 for details on the Black on Invalid Video mode.
Six BNCs are provided for the system's six Native Aux Outputs. Source
selection is performed in the Aux Assign Section on the panel. In Chapter 3,
refer to the "Aux Section" heading on page 60 for details.
2. FSN-1400 Orientation
If the user preference "Black on Invalid Video" is
turned on, the DSK turns off — because of the change
in output timing.
If the user preference "Black on Invalid Video" is off,
the DSK will be visible — but in a shifted position. In
this condition, the video position can be adjusted by
changing the output timing of the DSK source itself.
"User Preferences
Card Descriptions
Menu" section
45