Barco FSN Series User Manual page 32

2. FSN-1400 Orientation
Hardware Description
3)
^áê=cáäíÉê
An air filter is located on the inside of the front door, in the bottom half of the door. Using
the four thumb nuts, this filter can be easily removed and cleaned periodically, as required.
aççê=oÉãçî~ä=~åÇ=oÉJáåëí~ää~íáçå
Use the following steps to open and remove the FSN-1400 front door:
1.
2.
3.
4.
Use the following steps to re-install the FSN-1400 front door:
1.
2.
3.
4.
32
The Video Reference LED indicates the status of the system's analog video
reference input, via the Vid Ref connector on the System Card's rear I/O card.
~
Green = the system is configured for External Reference, a video
reference signal is present and the FSN-1400 is locked to the signal.
~
Red = the system is configured for External Reference, the signal is
missing or the FSN-1400 is not locked to the signal.
~
Off = the system is configured for Free Run.
Note If the Power LED is off, the Video Reference LED will also
be off.
Hinges
Two hinges are provided on the right side of the door, to facilitate door removal
and re-installation. See the
for door removal and installation instructions.
On the Latch, press inwards on the top label that reads "Push."
Lift the lower portion of the Latch that reads "Lift and Turn."
Turn the Latch clockwise, and open the door.
To remove the door, lift it up and off of its hinges.
Align the female hinges on the door with the male hinges on the FSN-1400.
Set the door down on the hinges until it is fully seated.
Close the door.
Turn the Latch counter-clockwise, then push the Latch in to re-seat it.
Important Operating the FSN-1400 without the door fully closed and the
filter installed will cause overheating and possible damage.
"Door Removal and Re-installation" section below
FSN Series • User's Guide