Barco FSN Series User Manual page 101

3.
4.
5.
6.
7.
FSN Series • User's Guide
(Optional) Using a BNC cable, connect an analog reference video input to the Ref
In connector.
~
Accepted signals are black burst, SMPTE bi-level sync and tri-level sync.
~
Computer sync is not an accepted signal.
Note In Appendix A, refer to the
Specifications" section on page 309 for detailed information
about the allowed frame rates for the reference input.
(Optional) Using a BNC cable, connect the Loop connector to the reference
video input on the next device in your video system.
Important If the reference Loop connection is not used, connect a 75
ohm terminator to the connector.
(Optional) Connect the supplied Tally "Y" Adapter to the Tally connector. This
adapter splits the DB-50 connector into two DB-25 female connectors, in order to
facilitate your individual tally connections. Next, connect the tally relays to your
video devices as required. In Appendix A, refer to the
on page 318 for pinouts.
For AC connections, one AC connector is provided for each FSN-1400 power
supply. Please note:
~
One supply is standard, the redundant supply is optional.
~
In a redundant configuration with both supplies installed, the FSN-1400
can be powered from two different circuit breakers.
Open the FSN-1400 front door and note the number of power supplies installed. If
only one supply is installed, note its location (in the top or bottom slot).
Connect the supplied AC Power Cord(s) to the AC connectors on the rear of the
FSN-1400, and then to AC outlet(s).
~
If a power supply is installed in the top slot, use AC Connector 1.
~
If a power supply is installed in the bottom slot, use AC Connector 2.
Note Connect the FSN-1400 to a properly rated supply circuit.
Reliable grounding of rack-mounted equipment should be
maintained. Refer to the
Selection" section on page 102 for details.
4. Installation
FSN-1400 System Connections
"Reference Video Input
"Tally Connector" section
"Power Cord/Line Voltage
101