Table of Contents
Advertisement
^ìíçã~íáÅ=jáñ=hÉó
Use the following steps to perform an automatic mix key:
1.
2.
3.
Please note the following important points regarding automatic mix keys:
•
•
j~åì~ä=táéÉ=hÉó
Use the following steps to perform a manual wipe key:
1.
2.
3.
4.
^ìíçã~íáÅ=táéÉ=hÉó
Use the following steps to perform an automatic wipe key:
1.
2.
3.
4.
Please note the following important points regarding automatic wipe keys:
•
•
FSN Series • User's Guide
Ensure that the key(s) you wish to transition are properly set up. Refer to the
"
Key Setup
" section for details.
In the Next Transition Group , select the layers that you wish to transition:
~
On the M/E, enable BG , KEY 1 and/or KEY 2 as desired.
~
On the PGM bank, enable BG and/or DSK as desired.
Press AUTO TRAN .
You can also press ALL TRAN (in the Custom Control Section ) to perform the
transition on all buses simultaneously.
Remember that there are a wide variety of auto-transition combinations available
to you. Refer to the "
Automatic Transitions
Ensure that the key(s) you wish to transition are properly set up. Refer to the
"
Key Setup
" section for details.
In the Next Transition Group , select the layers that you wish to transition:
~
On the M/E, enable BG , KEY 1 and/or KEY 2 as desired.
~
On the PGM bank, enable BG and/or DSK as desired.
Select the desired wipe pattern, direction, edge type, edge width, and edge color
(if a Hard Edge wipe is selected).
Use the T-Bar to perform the manual wipe key. The selected key(s) will transition
up or down, depending on their current state.
Ensure that the key(s) you wish to transition are properly set up. Refer to the
"
Key Setup
" section for details.
In the Next Transition Group , select the layers that you wish to transition:
~
On the M/E, enable BG , KEY 1 and/or KEY 2 as desired.
~
On the PGM bank, enable BG and/or DSK as desired.
Select the desired wipe pattern, direction, edge type, edge width, and edge color
(if a Hard Edge wipe is selected).
Press AUTO TRAN .
You can also press ALL TRAN (in the Custom Control Section ) to perform the
transition on all buses simultaneously.
Remember that there are a wide variety of auto-transition combinations available
to you. Refer to the "
Automatic Transitions
7. Operations
Working with Keys
" section on page 280 for details.
" section on page 280 for details.
289
Advertisement
Table of Contents
