Table of Contents
Advertisement
3. Control Panel Orientation
Control Panel Descriptions
2)
STORE
RECALL
3)
M/E 1
82
~
If you press CLEAR, the appropriate register clears and a dash appears.
However, the function (store or recall) remains active, along with the
selected modules.
~
If you turn off the STORE or RECALL button prior to pressing ENTER,
you effectively cancel the operation, and the appropriate register returns
to its previous value.
Function Section
The two buttons in the Function Section determine the memory function that you
want to perform. Only one button can be selected at a time.
~
To store a switcher setup in memory:
•
Press STORE to initiate the procedure.
•
Select the module(s) to be included in the register.
•
Enter a register number.
•
Press ENTER.
~
To recall a switcher setup from memory:
•
Press RECALL to initiate the procedure.
•
Enter a register number.
•
Press ENTER.
Note
It is not necessary to select modules for a recall. When you
press RECALL and enter digits, the module buttons
associated with the stored register(s) will automatically light.
~
To cancel a "store" or "recall" function, turn the STORE or RECALL
button off, prior to pressing ENTER.
~
To display the Memory Menu on the Touch Screen, press and hold
either STORE or RECALL.
In Chapter 7, refer to the
"Working with Memory
for more information.
Module Section
The eight buttons in the Module Section select the switcher modules and
functions to be included in the selected store or recall operation. Please note:
~
Each button is a toggle — press to enable, press again to disable. The
buttons are not mutually exclusive.
•
For a store procedure, one or more modules must be selected,
and any combination can be included in the memory register.
•
For a recall procedure, you cannot add modules to a register
already stored, but you can remove modules from a recall.
~
It is not necessary to select modules for a recall procedure. When you
press RECALL and enter digits, the modules associated with the stored
register(s) will automatically light.
Following are descriptions of each button in the Module Section:
~
Press M/E 1 to include the entire M/E 1 bank in a store procedure, or
remove the bank from a recall procedure. Using the Memory Menu, if
desired, you can elect to include or exclude certain sub-sections of M/E 1
in the procedure.
Registers" section on page 291
FSN Series • User's Guide
Advertisement
Table of Contents
