Barco FSN Series User Manual page 245

oÉíìêå=íç=c~Åíçêó=aÉÑ~ìäí
FSN Series system setup: Step 2 .
Prior to performing any setup procedures, it is recommended that you perform a factory
2
reset — in order to reset all input, output and source mappings to their default values.
Particularly for customers in the events and rental marketplace, this procedure guarantees
that any previous input setups and memory registers (e.g., those that may have been
programmed by other users) are completely cleared from system memory.
Use the following steps to return the system to factory default values:
1.
2.
3.
4.
FSN Series • User's Guide
Note If you are continuing an event (for example, day two of a
three-day event), you do not need to perform a factory reset.
However, if you do elect to perform a factory reset, ensure
that you have backed up your system. Refer to the "
up the System
Prerequisite — Ensure that you are familiar with the Reset Menu . In
Chapter 5, refer to the "
In the Menu Bar , press {System} to access the System Menu .
Press {Reset} to display the Reset Menu .
Press {Factory Reset} to reset the entire system to its factory default values.
Remember that all data will be lost.
When the Reset Confirmation Pop-up appears, press
Note In Chapter 5, refer to the "
on page 236 for a list of factory default settings.
" section on page 262 for details.
Reset Menu " section on page 235.
Factory Default Settings
6. System Setup
Return to Factory Default
Backing
{ }
YES .
" section
245