Barco FSN Series User Manual page 77

7)
MIX
KEY 1
CUT
KEY 1
Figure 3-16. Direct Key Control Group
MIX
KEY 1
MIX
KEY 2
CUT
KEY 1
CUT
KEY 2
FSN Series • User's Guide
Note
You can use AUTO TRAN and the T-Bar together. For
example, you can start a transition manually, and continue it
automatically. In Chapter 7, refer to the
Mixes" section on page 285 for full details.
Direct Key Control Group
The four buttons in the Direct Key Control Group enable you to directly control
the two keyers in the M/E, without the need to "arm" them in the Next Transition
Group. When you use these four buttons, the red LEDs above the KEY 1 and
KEY 2 buttons function in the normal manner.
MIX
KEY 2
CUT
KEY 2
Following are descriptions of each button in the Direct Key Control Group:
~
Press MIX KEY 1 to immediately mix Key 1 fully on or fully off.
~
Press MIX KEY 2 to immediately mix Key 2 fully on or fully off.
~
Press CUT KEY 1 to immediately cut Key 1 fully on or fully off.
~
Press CUT KEY 2 to immediately cut Key 2 fully on or fully off
Please note the following important points regarding the Direct Control buttons:
~
Unlike the AUTO TRANS button, the two MIX KEY buttons cannot be
paused. Once pressed, the transition completes fully.
~
When the T-Bar is positioned between the BG and PST buses (off of a
limit), almost all transitions are possible. For example:
BG + MIX enabled — if the T-Bar is positioned half-way between the
BG and PST buses (creating a 50% mix), pressing CUT KEY 1 cuts
the key in (or out) over the mix.
BG + WIPE enabled — if the T-Bar is positioned half-way between
the BG and PST buses (creating a split-screen wipe), pressing MIX
KEY 2 mixes in the key over the split screen.
KEY 1 + MIX enabled — if the T-Bar is positioned half-way between
the BG and PST buses (creating a 50% mix of the key), pressing
MIX KEY 1 mixes in the key to 100%.
KEY 1 + WIPE enabled — if the T-Bar is positioned half-way
between the BG and PST buses (wiping the key halfway on),
pressing MIX KEY 1 is inhibited. However, pressing CUT KEY 1
can be performed.
3. Control Panel Orientation
Control Panel Descriptions
"Working with
77